Explosion panels

In response to the growing demand for pressure relief solutions, we now present various solutions online. The explosion panels are often used in the food industry, petrochemical industry, at Defense and in high-voltage network companies. The explosion panel is also referred to as a 'plop hatch' and serves as a pressure relief in case of gas, dust, electric (short-circuit) or chemical explosions. JAZO explosion panels are exclusively used in walls/facades.

JAZO explosiepaneelThe panels are provided with a Compro-ERM module (Explosion Release Mechanism) which ensures the panel to open at a preset excess pressure on the inside of the panel. After an explosion the certified (breaking)modules must be checked in Compro-ERM and replaced if necessary. The panel closes after the explosion and will not fragment.

The panel should be free of obstacles both on the inside and on the outside. The panels will remain closed at high wind pressure and wind suction and are available in aluminum, steel and stainless steel. They can be supplied as a separate panel border or as part of a facade. The calculation for the required size and opening pressure is to be carried out or verified by a competent engineer.

In addition, the following configurations are possible:

Minimum size: width x height 1000x656 mm
Maximum size: width x height 3000x1456 mm
Opening pressure: on request, standard 5 mbar, 7 mbar, 10 mbar 
Burglar resistance:           RC2, RC3, RC4 or none
Fire resistance: EW 30, 60, 90 min or none
Isolation (heat/noise): on request
Ventilation: with ventilation panel or grid louver
Applicable standards:

NEN-EN 1991-1-7:2006/A1:2014
NEN-EN 1634
NEN-EN 1628, 1629, 1630
NEN 5096

Below an explanation of the operation our explosion panel.

Kies weergave
Lines Group
Fire resistance
Extra specifications
Burglary proof
Do you have any questions or would you like advice? 0316 - 59 29 11